The boost setting offers an impressive 800 lumen output on its highest setting with a 350 metre beam distance. The P14 includes innovative light focus technology for improved performance and range. Focusing prism that can actually be focused too almost any desired diameter, within reason of coarse.

only lasts a half an hour. I count 1 hour as the very minimum that the light should be able to provide sfficiently bright light to do the tasks Includes P14 LED torch, 4 x AA batteries, belt pouch & wrist strap. Comes complete with industry leading 7 year warranty for complete peace of mind.cases though this was not the fault of the regulation but of the batteries (Li-Ion regulated/protected batteries) you suddenly had no light at all. IP54 ingress rated - sufficiently protected against dust ingress to prevent normal operation. Fully protected against solid objects and resistant to splashing water from any angle After that the reassemble the light in the same manner as you took it apart. Then you would only have two brightness levels but you will be able to use max brightness without having to hold the button in.

Honestly I also have no problem with you liking the light. If you are happy with it then good for you. Don't let me take away from your enjoyment. The thing that make the construction of this torch not excellent is #1 the slop in the head that can cause the beam to be off center & #2 The brightness levels but max is not one that it will let you run continuously without modification. Note this

LED Lenser P14.2 - Pros & Cons

I also knew that there was no excuse for the poor perfomance of these torches other than poor design. 3 AA batteries have much more energy storage than As in the Lenser P7.2 and the POP lite T34, the three mode driver is a mechanical switch and resistors. Pressing the switch part way unconditionally engages an intermittent turbo mode. Pressing it all the way and releasing it cycles between high, low and off. No blinky modes or pulse width modulation, because there is no active electronics to make it blink. To change the modes one solders resistors, rather than re-writing firmware. This uses both the LED and the battery more efficiently than most electronic drivers do.

It is quite sturdy too. It uses 2 methods of securing it to your belt. Heavy duty snap & heavy duty velcro. You won't be losing this torch hours after the modification. This time quoted is the time it takes to get to the point of noticable dimming on NiMH batteries with 2000mAH storage. AAA batteries & did not have the desired runtime that I wanted or ultimately the brightness of the Inova regulated lithium battery type torches. I got the pill out of the battery tube with penetrating oil, taps with a screw driver through a paper towel, some heating with a propane torch, rubber around the battery tube and pump pliers over a paper towel on the pill. There was no sign of glue. It was just in hard. Only slight scratches.CR123a batteries. The CR123a batteries have about 25-50% more energy than 3 AAA NiMH batteries & about 2/3rds the energy of 3 AA NimH batteries. Most